Removing The Zūmo And Mounts; Caring For Your Zūmo - Garmin Zumo 660 Owner's Manual

Removing the zūmo and
Mounts
To remove the zūmo from the cradle on both
the suction cup and motorcyle mounts, press
the button on the side of the cradle, and tilt
the zūmo forward. Place the weather cap on
the motorcyle mount cradle.
To remove the cradle from the suction cup
mount, turn the cradle to the right or the left.
Apply pressure until the socket on the cradle
releases the ball on the mount.
noTe: Reconnecting the cradle to the
suction cup mount requires significant
force. Press the ball end firmly into the
socket.
To remove the suction cup mount from the
windshield, flip the lever toward you. Pull
the tab on the suction cup toward you.
zūmo 600 Series Owner's Manual
Caring for Your zūmo
Your zūmo contains sensitive electronic
components that can be permanently
damaged if exposed to excessive shock
or vibration outside normal motorcycle or
automobile use. To minimize the risk of
damage to your zūmo, avoid dropping your
unit and operating it in extreme high-shock
and high-vibration environments.
Cleaning the Casing
The zūmo is constructed of high-quality
materials and does not require user
maintenance other than cleaning. Clean the
outer casing (not the touchscreen) using
a cloth dampened with a mild detergent
solution, and then wipe dry. Avoid chemical
cleaners and solvents that can damage plastic
components.
Cleaning the Touchscreen
Clean the touchscreen with a soft, clean,
lint-free cloth. Use water, isopropyl alcohol,
or eyeglass cleaner, if needed. Apply the
liquid to the cloth, and then gently wipe the
touchscreen.
Protecting Your zūmo
• Do not store the zūmo where prolonged
exposure to extreme temperatures can
occur, because it can cause permanent
damage.
• Though a PDA stylus can be used to
operate the touchscreen, never attempt
this while operating a vehicle. Never
use a hard or sharp object to operate the
touchscreen, or damage may result.
Appendix
41