About Gps Satellite Signals; Mounting On Your Dashboard; Removing The Zūmo And Mounts - Garmin ZUMO 665 Owner's Manual

Appendix

About GPS Satellite Signals

Your zūmo must acquire GPS (Global
Positioning System) satellite signals to
navigate. If you are indoors, near tall
buildings or trees, or in a parking garage,
your zūmo cannot acquire satellites. Go
outside to an area free from tall obstructions
to use your zūmo.
When your zūmo has acquired satellite
signals, the signal strength bars on the Menu
page are green . When it loses satellite
signals, the bars turn red or clear
For more information about GPS, go to
www.garmin.com/aboutGPS.
44
Mounting on Your
Dashboard
Notice
The permanent mounting adhesive is
extremely difficult to remove after it is
installed.
Use the enclosed mounting disk to mount
your unit to the dashboard and comply with
certain state regulations.
1. Clean and dry the dashboard where you
are placing the disk.
.
2. Remove the backing from the adhesive
on the bottom of the disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover from the
top of the disk.
5. Place the suction cup mount on top of
the disk. Flip the lever down (toward the
disk).
Removing the zūmo and
Mounts
To remove the zūmo from the cradle on both
the suction cup and motorcycle mounts,
press the button on the side of the cradle, and
tilt the zūmo forward. Place the weather cap
on the motorcycle mount cradle.
To remove the cradle from the suction cup
mount, turn the cradle to the right or the left.
Apply pressure until the socket on the cradle
releases the ball on the mount.
NOTE: Reconnecting the cradle to the
suction cup mount requires significant force.
Press the ball end firmly into the socket.
To remove the suction cup mount from the
windshield, flip the lever toward you. Pull
the tab on the suction cup toward you.
zūmo 665 Owner's Manual