Options Et Accessoires - Carrier AquaSnap 61AF 022 Installation, Operation And Maintenance Instructions

12 - OPTIONS ET ACCESSOIRES

Options
Corrosion protection,
traditional coils
Unit with ductable fans
Low noise level
Very low noise level
Protection grilles
Soft Starter
Water Exchanger frost
protection
Master/slave operation
LP VSD single-pump
Modbus over IP and RS485
Lon gateway
Bacnet over IP
Compliance with Russian
regulations
Condenser screw connection
sleeves kit
Welded condenser water
connection kit
Set point adjustment by
4-20mA signal
Accessories
00PPG000488000- Heating System
Manager type A: controls one heat
emitter type with an auxiliary electric
heater or boile
00PPG000488100- Heating System
Manager type B: controls two heat
emitter types (or independent zones)
and domestic hot water production
with an auxiliary electric heater or
boiler
00PPG000488200- Heating System
Manager type C: controls two heat
emitter types (or independent zones)
and domestic hot water production
with a district heating system as
auxiliary source
N° Description
Fins made of pre-treated aluminium
3A
(polyurethane and epoxy)
Fans with 100 Pa maximum available
11
pressure
Aesthetic and sound absorbing
15
compressor enclosure
Aesthetic and sound absorbing
15LS compressor enclosure associated with
low-speed fans
23 Metallic protection grilles
25 Electronic starter on each compressor
42 Electric heater on the hydraulic module
Unit equipped with supplementary water
outlet temperature sensor kit to be
58 field-installed allowing master/slave
operation of two units connected in
parallel
Variable speed single pump, For more
116X details, refer to the dedicated chapter
(expansion tank not included)
Bi-directional high-speed
149B communication using Modbus protocol
over Ethernet network (IP)
Bi-directional communication board
148D
complying with Lon Talk protocol
Two-directional high-speed
149 communication using BACnet protocol
over Ethernet network (IP)
199 EAC certification
265 Condenser inlet/outlet screw connection
sleeves
Victaulic piping connections with welded
267
joints
Connections to allow a 4-20mA signal
311
input
Description
Additional control box not supplied with
the unit, to be installed remotely
Additional control box not supplied with
the unit, to be installed remotely
Additional control box not supplied with
the unit, to be installed remotely
Advantages
Improved corrosion resistance, recommended for
moderate marine and urban environments
Allows connection to discharge ducts in order to
facilitate air evacuation
Noise level reduction by 1 to 2 dB(A)
Noise level reduction for sensible site
Coil protection against possible impact
Reduced start-up current
hydraulic module frost protection at low outside
temperatures down to -20°C
Optimised operation of two units connected in
parrallele operation with operating time
equalisation
Easy and fast installation (plug & play),significant
pumping energy cost savings (more than
twothirds), tighter water flow control, improved
sytem reliability
Easy and high-speed connection by ethernet line
to a building management system. Allows access
to multiple unit parameters
Connects the unit by communication bus to a
building management system
Easy and high-speed connection by ethernet line
to a building management system. Allows access
to multiple unit parameters
Conformance with Russian regulations
Allows unit connection to a screw connector
Easy installation
Easy energy managment, allow to adjust set point
by a 4-20mA external signal
Advantages
Heating system control facilitated
Heating system control facilitated
Heating system control facilitated
Use
61AF 022-105
61AF 035-105
61AF 022-105
61AF 035-105
61AF 022-105
61AF 022-105
61AF 022-105
with option
116X
61AF 022-105
61AF 022-105
61AF 022-105
61AF 022-105
61AF 022-105
61AF 022-105
61AF 022-105
61AF 035-105
61AF 022-105
Use
61AF 022-105
61AF 022-105
61AF 022-105