Table of Contents
Advertisement
3
Check that the unit of mea-
surement has been switched.
◆ "CHE" will disappear and the unit of
measurement is displayed.
4
Release the RESET button.
◆ The READY lamp will light up, indi-
cating that the instrument is ready for
measurement.
◆ Switching of the unit of measurement
is performed only once.
The unit of measurement will not be
switched even if the RESET button is
kept pressed.
To switch the unit of measurement
again, set the POWER switch to OFF,
and then repeat the above steps from
step 1.
5
Set the POWER switch to
OFF.
20
When switching the unit of measurement, the one for the
previous measurement will not be displayed. The newly
selected unit of measurement is displayed. (An example
of switching from "mg/dL" to "μmol/L" is shown above.)
The unit for the previous
measurement
Advertisement
Table of Contents
