Table of Contents
Advertisement
INITIAL SETUP
Proceed to activate the system after checking that the pipe connections are secure and that the system is
connected to a water source and power supply.
• Ensure the stop valve on the incoming water pipe is 'on'. Turn on the filter faucet and wait for the first
flow of water. Allow some time for the water to pass through all filters. If there is no water flowing out of
the faucet, check if the incoming water pressure is too low.
• When the filter faucet has been running for about 10 minutes, check the body of the filter for any visible
leaks. Ensure all pipe and wire connections are secure.
• Close off the filter faucet and check to see if the flow of water at the waste water tube stops. The flow
should stop within 30 seconds.
INSTRUCTIONS BEFORE USE
• Before the water can be consumed, the system requires a thorough flush of the the Reverse Osmosis
filter. You can do this by letting the filter faucet run for 20 minutes every 2 hours, repeated 7 times.
Alternatively, let the faucet run for as long as possible on the first day of installation.
• Gas solubility increases as tap water passes through the high-pressure RO filtration process. As a result,
users may notice tiny bubbles in the pure water, similar to that of bubbles of carbonated drinks. Because
pure water has no impurities, it takes a long time for the bubbles to dissipate. This is a normal physical
phenomenon and is harmless to the human body.
• Switch off the filter faucet when not in use.
• Used filters cannot be cleaned and recycled. They should be disposed off as solid domestic waste.
• If product has not been in use for a long time, reset the system, disconnect and reconnect the water
source, and perform a thorough flush before you use resume use.
• Should any of the following situations occur, disconnect the water source immediately and power down
the system:
- Leak detected at any part of the main body or connecting pipes
- Any part of the system is malfunctioning
• Should any part of the system be damaged, seek professional assistance from an authorised A. O. Smith
retailer. The manufacturer is not responsible for any loss as a result of failure to operate the system in
accordance with the instructions in this manual.
Advertisement
Table of Contents
