Table of Contents
Advertisement
Tip:
Before insertion of water pipe into the faucet body, draw a line 16mm away from the end of the water
pipe as a guide. After the water pipe is inserted, the marking line should not be visible.
To prevent internal damage, do not force the main body while it rotates into the base.
Note: When cleaning the surface of the faucet, use a soft sponge. Avoid metal sponges to prevent scratches
and damage. A faucet damaged in this manner will not be covered under the warranty.
INSTALLATION OF WASTE WATER PIPE
Installers are advised to use the waste water clamp.
Use a 3mm drill bit to make a small hole in the existing drain pipe and fix the waste water clamp to the hole.
Connect one end of a flexible water hose into the waste water clamp hole.
Align and fix the waste water clamp, connecting the 2-way waste water pipe with the small hole of the drain
pipe. Ensure the inserted portion of the 2-way water pipe does not exceed 1.5 cm.
Tip: Before insertion, coat the connection of the 2-way pipe and the drain pipe with a little silica gel.
FIXING THE SYSTEM
The reverse osmosis water purifier is not to be wall-mounted. It
should be placed directly on the cabinet floor. Should the unit need
to be fixed on the wall, the user must purchase a separate tripod and
expansion screws for a secure wall-installation.
• Remove the foam from the packing box
• Place the foam on the bottom of the product, as shown in the figure.
POWER CORD CONNECTION
Connect the power adapter to the system and insert the power plug into the electric socket.
INSTALLATION PRECAUTIONS
• At the bottom of the system there is a water pump. The four screws at the base of the pump should be
removed before the installation or an abnormal noise will sound.
• Use the provided pipe plugs to fix the water pipes. All screw caps should also be used.
• Use the new hose assembly provided with the appliance.
• If the system is installed correctly, you should be able to slot in and install the filters easily. If this is not so,
do not use force the filters in. The use of force may cause permanent damage to the circuit board and filter
microchip. This will not be covered by the warranty.
Advertisement
Table of Contents
