Chapter 3
Jumper Settings and Connectors
This chapter will assist you in setting up the SA486P AIO before you install it in a
system case. If your SA486P AIO has already been installed and you do not wish
to change the configuration settings, you can skip over this section.
Jumper Settings
3.1
The SA486P AIO has several jumper switches that must be set to define a system
:onfiguration. These switches are 2-pin, 3-pin, 4-pin components on the main
board. They are turned off and on by placing or removing a cover cap over the
pins. This is called a short or closed jumper. All jumpers must be set to one of the
possible two settings.
Figure 3. 1 on the following page shows the location of the jumpers and connectors.
Jumper Settings
and
Connectors
3- 1