Quick Start Guide
Network Camera
Anchors & Screws
*Images may differ from actual products.
1
Wall/Ceiling Mounting
Option 1: Cable through the wall/ceiling
1. Drill Holes
Stick the mounting template to the desired mounting place. Drill
3 screw holes and 1 cable hole according to the template.
2. Open the Camera Case
Align the notch of the camera body with any score on the camera
base, and use a screwdriver to gently pry open the camera case.
Notch of
3. Secure the Camera
Route the cable through the wall/ceiling. Insert anchors into the holes,
use screws to affix the camera base, and attach the camera to it.
4. Adjust the Surveillance Angle
Adjust the surveillance angle as needed. Make sure the lens is
positioned above the IR LED for normal viewing.
Tilt: 0° to 85°
Mounting Template
Quick Start Guide
Cable Hole
(For the cable through wall/ceiling)
Notch of
camera body
Pan: 0° to 360°
Rotate: 0° to 360°
Appearance
1
2
3
4
Quick
Start
Guide
*The camera's standard power supply is 12V DC or PoE (802.3af/at). The
power source should meet LPS, PS2, and other requirements according to IEC
62368-1.
Option 2: Cable through the side outlet
1. Drill Holes
Stick the mounting template to the desired mounting place. Drill
3 screw holes according to the template.
2. Open the Camera Case
Align the notch of the camera body with any score on the camera
base, and use a screwdriver to gently pry open the camera case.
Notch of
3. Secure the Camera
Route the cable through the side outlet. Insert anchors into the holes,
use screws to affix the camera base, and attach the camera to it.
4. Adjust the Surveillance Angle
Adjust the surveillance angle as needed. Make sure the lens is
positioned above the IR LED for normal viewing.
Tilt: 0° to 85°
Side Outlet
1
Camera Base
2
Camera
4
Lens
5
IR LED
6
5
7
6
8
Power Supply Interface
8
(12V DC) *
Notch of
camera body
Side Outlet
Pan: 0° to 360°
Rotate: 0° to 360°