Choosing The Right Installation Location - Hunter Anorak Installation Manual

1886
You probably bought this fan with a location in mind. Let's check below to make sure it is a good fit.
Check the room dimensions:
30 inches
from blade tip to
nearest wall or
obstruction
from bottom edge
of blade to the
To avoid possible electrical shock, before installing your fan,
disconnect the power by turning off the circuit breakers to the
outlet box associated with the wall switch location.
Do this first!
WARNING
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
OFF
1
Remove all four
mounting isolators.
3
Ceiling Bracket Downrod

Choosing the Right Installation Location

7 feet
floor
Preparing the Ceiling Bracket
2
Align the tapered mounting holes in the ceiling plate
with the holes in the ceiling bracket. Install the four
ceiling plate screws found in the
secure with the flange nuts using an 9/32" wrench.
Hold the ceiling bracket assembly up to the outlet box
and mark the screw locations. To mount to support
structure, also mark the ceiling for drilling pilot holes.
Hanging Fan Wiring
Check the outlet box:
x4
Canopy Plate Screw
x4
bag
Flange Nuts
hardware bag and
Canopy Blades
You must be able to
secure the fan to building
structure or fan-rated
outlet box.
3
Install the ceiling plate gasket onto
the ceiling plate. The four holes in
the ceiling plate should lineup with
the four posts in the gasket.
Light Glass Control