Page 2
- All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 3
Here is what comes in your box: 1886 Hunter Pro Tip: We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Do not discard the hardware bags or mix parts from different bags.
1886 Choosing the Right Installation Location You probably bought this fan with a location in mind. Let’s check below to make sure it is a good fit. Check the room dimensions: Check the outlet box: 30 inches You must be able to secure the fan to building from blade tip to structure or fan-rated...
Installing the Ceiling Bracket You have two options for installation. Pick which one works best for your location. Remove any existing bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. Hunter Pro Tip:...
Follow below if you are using the downrod that came pre-assembled in your box. Need to install a longer or shorter downrod? Check out the guide at the end of this manual. Hunter Pro Tip: The ground wire attached to the downrod is approximately 8 inches.
Follow these steps to get your fan wired quickly and safely. If you are unfamiliar with wiring or uncomfortable doing it your- self, please contact a quali ed electrician. Hunter Pro Tip: Here is how to connect the wires: Push the bare metal ends of the wires together and slide a wire nut over them.
1886 Installing the Canopy Insert the two canopy screws found in the hardware bag. Canopy Screw Lift the canopy into place so that the screw holes are aligned. Installing the Blades: Put the blade washers found in the hardware bag onto the blade screws found in the hardware bag.
Page 9
1886 Assembling the Light 1 of 3 2 of 3 Switch Housing Switch Housing Screw Screw Feed the wire plug through the center hole of the uppers switch housing. Align the keyhole slots in the upper Partially install two switch housing screws, found switch housing with the two screws you just installed.
Page 10
1886 Preparing the Wall Control Wiring the Wall Control Turning off the power Installing the battery Ensure the power Connect the grounding wire To access the battery is OFF at the outlet from the wall control to the compartment, slide the battery box and wall switch ground control from the switch door up.
• Use the provided balancing kit and instructions to balance the fan. Remote Control of Fan is Erratic • Make sure the battery is installed correctly. • Install a fresh battery. Hunter Pro Tip: Cleaning the Fan Use soft brushes or cloths to prevent scratching. Cleaning products may damage the finishes.
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,...