Setting Language; Setting Data Function - Motorola MXP600 Feature User Manual

Option
Keypad Vol
Tones Vol
Call-Out Vol
NOTE: If the display shows only one option Volume, you can adjust all of the above
settings at once. You have the option to change the settings individually when the
Volume Adj. Mode is set to Individual.
5 Press Right or Left Navigation key to change the value.
NOTE: When the battery level is low it is not recommended to attach the 4 Ω speaker to
the radio as it can cause reset or shutdown of the radio.
19.4

Setting Language

Prerequisites:Your service provider sets the available list of languags.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Language.
3 Select desired language.
19.5

Setting Data Function

You can set up your radio to transmit and receive data from an external device.
NOTE:
When set to Voice Only, the built-in data modem is disabled to conserve battery power.
Prerequisites:
Connect your radio accessory connector to an external device using the PMKN4127 or PMKN4129
cable.
The external device must run an application complying with TETRA standards.
Enter Trunked Mode Operation (TMO) only and not Transmit Inhibit Mode (TXI).
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Data Setup.
3 Select one of the following options:
Option
Voice Only
Data Only
Voice & Data
Description
Sets the volume level for keypad tones.
Sets the volume level for alert tones.
Sets the volume level for Call-Out tones (if enabled).
Description
Your radio receives and transmits voice calls only.
Your radio acts as a modem. It rejects incoming and
outgoing voice calls (except for Emergency Calls), status
and text messages.
Your radio acts as a modem but voice calls have priority
over data calls and can interrupt them.
MN006360A01-AE
Chapter 19: Setup
111