Configuring Ht814 Through Voice Prompts; Configuration Through A Central Server - Grandstream Networks HT814 Administration Manual

https://arttel.ru/

Configuring HT814 Through Voice Prompts

As mentioned previously, The HT814 have a built-in voice prompt menu for simple device configuration.
Please refer to
about IVR and how to access its menu.
 DHCP MODE
Select voice menu option 01 to enable HT814 to use DHCP.
 STATIC IP MODE
Select voice menu option 01 to enable HT814 to use STATIC IP mode, then use option 02, 03, 04, 05 to
set up IP address, Subnet Mask, Gateway and DNS server respectively.
 PPPOE MODE
Select voice menu option 01 to allow the HT814 to enable the PPPoE mode. PPPoE Username and
Password should be configured from web GUI.
 FIRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
 CONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
 UPGRADE PROTOCOL
Select the menu option 15 to choose firmware and configuration upgrade protocol between TFTP / HTTP.
 FIRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1) Always check, 2) check when pre/suffix changes, and 3) never upgrade.
 WAN PORT WEB ACCESS
Select voice menu option 12 to enable/disable web access from WAN port. Press 9 in this menu to toggle
between enable / disable. Default is disabled.

Configuration Through a Central Server

The HT814 can be automatically configured from a central provisioning system. When HT814 boots up, it
will send TFTP or HTTP/HTTPS requests to download configuration files, "cfg000b82xxxxxx" and
"cfg00082xxxxxx.xml", where "000b82xxxxxx" is the LAN MAC address of the HT814. If the download of
"cfgxxxxxxxxxxxx.xml" is not successful, the provision program will issue request a generic configuration
file "cfg.xml". Configuration file name should be in lower case letters. The configuration data can be
downloaded via TFTP or HTTP/HTTPS from the central server. A service provider or an enterprise with
large deployment of HT814 can easily manage the configuration and service provisioning of individual
devices remotely from a central server. Grandstream provides a central provisioning system GAPS
(Grandstream Automated Provisioning System) to support automated configuration of Grandstream
devices. GAPS uses enhanced (NAT friendly) TFTP or HTTP (thus no NAT issues) and other
communication protocols to communicate with each individual Grandstream device for firmware upgrade,
remote reboot, etc. Grandstream provides GAPS service to VoIP service providers. Use GAPS for either
https://arttel.ru/shop/voip-shlyuzy/grandstream-ht-814
"Understanding HT814 Interactive Voice Prompt Response
HT814 Administration Guide
Menu" for more information
P a g e | 43