Configuring Ht81X Through Voice Prompts; Figure 11: Web Http Port - Grandstream Networks HT818 User Manual

Configuring HT81X Through Voice Prompts

As mentioned previously, The HT81X has a built-in voice prompt menu for simple device configuration.
Please refer to "Understanding HT81X Interactive Voice Prompt Response
about IVR and how to access its menu.
• DHCP MODE
Select voice menu option 01 to allow the HT81X to use DHCP.
• STATIC IP MODE
Select voice menu option 01 to allow the HT81X to enable the STATIC IP mode, then use option 02, 03,
04, 05 to set up IP address, Subnet Mask, Gateway and DNS server respectively.
• PPPOE MODE
Select voice menu option 01 to allow the HT81X to enable the PPPoE mode. PPPoE Username and
Password should be configured from web GUI.
• FIRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
• CONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
• UPGRADE PROTOCOL
Select the menu option 15 to choose firmware and configuration upgrade protocol between TFTP, HTTP
and HTTPS.
• FIRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
"Always check, check when pre/suffix changes, and never upgrade".
• WAN PORT WEB ACCESS
Select voice menu option 12 to enable/disable web access from WAN port. Press 9 in this menu to toggle
between enable / disable.

Figure 11: Web HTTP Port

HT81x User Guide
Menu" for more information
P a g e | 24