https://arttel.ru/
DC Power
Reset
Connecting HT814
The HT814 are designed for easy configuration and easy installation, to connect your HT814, please
follow the steps below:
Scenario 1: Connecting the HT814 using WAN Port
When connecting HT814 using the WAN port, it will act as simple DHCP Client.
1. Insert a standard RJ11 telephone cable into the p hone ports and connect the other end of the
telephone cable to a standard touch-tone analog telephone.
2. Connect the WAN port of the HT814 to a router, switch or modem using an Ethernet cable.
3. Insert the power adapter into the HT814 and connect it to a wall outlet and make sure to respect
the technical specifications of the power adapter used (12V-1A).
4. Power, WAN and Phone LEDs will be solidly lit when the HT814 is ready for use.
Scenario 2: Connecting the HT814 using LAN Port
When connecting the HT814 using the LAN port, it will act as a router and DHCP serving addresses, the
devices connected with HT814 LAN will pull DHCP addresses from your HT814.
Insert a standard RJ11 telephone cable into the p hone ports and connect the other end of the
1.
telephone cable to a standard touch-tone analog telephone.
Connect a computer or switch to the LAN port of the HT814 using an Ethernet Cable.
2.
Insert the power adapter into the HT814 and connect it to a wall outlet and make sure to respect
3.
the technical specifications of the power adapter used (12V-1A).
4.
Power, LAN and Phone LEDs will be solidly lit when the HT814 is ready for use.
Note: Please make sure to enable NAT Router under Web GUI -> Basic Settings -> Device Mode.
https://arttel.ru/shop/voip-shlyuzy/grandstream-ht-814
LAN
Connects the phone adapter to your PC or switch using an Ethernet RJ45
network cable.
Powers the phone adapter. (12V – 1A )
Factory reset button. Press for 7 seconds to reset factory default settings.
HT814 Administration Guide
P a g e
|
13