Configuring The Device - Siemens SIMATIC NET RUGGEDCOM RS940GF Installation Manual

Device Management
3.2 Configuring the Device
The following is the pin-out for the port:
Figure 3.1
a
Connected internally.
b
Connected internally.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RUGGEDCOM RS940GF console and Web interfaces via
the device's IP address. The factory default IP address for the RUGGEDCOM RS940GF
is https://192.168.0.1.
For more information about available ports, refer to
21)".
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RUGGEDCOM
RS940GF interface. For more information about configuring the device, refer to
the RUGGEDCOM RUGGEDCOM RS940GF User Guide associated with the installed
software release.
20
5 1
9 6
Serial DB9 Console Port
Pin Name
a
1 Reserved (Do Not Connect)
2 TX
3 RX
a
4 Reserved (Do Not Connect)
5 GND
a
6 Reserved (Do Not Connect)
b
7 Reserved (Do Not Connect)
b
8 Reserved (Do Not Connect)
9 Reserved (Do Not Connect)
"Communication Ports (Page
Installation Manual, 01/2021, C79000-G8976-1356-04
Description
Transmit Data
Receive Data
Signal Ground
RUGGEDCOM RS940GF