Scanning Radio Channels - Uniden UM725GBT Owner's Manual

SCANNING RADIO CHANNELS

Scan Mode sequentially checks channels that
you have saved in memory. You must have at
least two channels saved in memory to start a
scan.
To scan saved channels, press the MEMSCAN
soft key. To scan all channels, press the
ALLSCAN soft key.
The radio scans channels
according to your radio settings,
including Priority and Weather Alert
watch, if set. If the radio detects
a transmission, it stays on that
channel; when the signal stops, the
radio resumes scanning. When the
radio receives a transmission, it
pauses the scan and stays on the
transmitting channel. Press ▲ or ▼
to leave that channel and resume
scanning.
To end the scan, press the SCAN
soft key. The radio remains on the last scanned channel.
Tip: If your radio stops on a transmission during ALLSCAN, you may want to save the channel to
memory, so that you can easily return to the channel again later or include it when you
perform a MEMSCAN.
TO SAVE CHANNELS FOR MEMORY SCAN:
1. Press the MENU button on your radio
and then use the PUSH/SEL knob to
access the SET SCAN CH menu. The
Set Scan CH screen appears
2. From here, you can use the PUSH/SEL
knob and ▲ or ▼ buttons to select a
channel, then press the SELECT soft
key to toggle the channels on or off for
scanning.
3. (Optional) Press RESET to turn all
channels off.
08 10
The radio scans about
10 channels per second
Uniden UM725 Radio Owner's Manual
Scan resumes when the signal stops.
The radio stops for
a detected signal
11 12 13 14
17
15
UM725GBT
UM725GBT
E-17