Table of Contents
Advertisement
Hardware Setup
Power Switch
Connect to a 2-pin push button switch.
Reset Switch
Reset switch is used to reboot the system rather than turning the power ON/
OFF. Avoid rebooting while the HDD LED is lit. You can connect the Reset
switch from the system case to this pin.
Power LED
The Power LED is lit while the system power is on. Connect the Power LED
from the system case to this pin.
Speaker (JFP1)
Speaker from the system case is connected to this pin.
HDD LED
HDD LED shows the activity of a hard disk drive. Avoid turning the power
off while the HDD LED is lit. You can connect the HDD LED from the
system case to this pin.
Keylock (JFP1)
Keylock allows you to disable the keyboard for security purpose. You can
connect the keylock to this connector.
2-15
Advertisement
Table of Contents
