Connecting The Power Supply - Brother P-touch P900W Quick Start Manual

Connecting the Power Supply

AC Adapter
Use the AD9100ESA (AC adapter) for this machine. Connect the AC adapter
directly to the machine.
1.
Insert the plug on the AC adapter cord into the AC adapter socket
marked DC IN 24 V on the machine.
2.
Insert the plug on the power supply cord into the AC adapter.
1 AC adapter
2 Power supply cord
3.
Insert the power supply plug into a standard electrical socket.
IMPORTANT
• Turn the machine off before disconnecting the AC adapter.
• Do not pull or bend the AC adapter cord and power supply cord.
• After the power supply plug is inserted into the electrical socket, it
may take a few seconds until the
Using the Rechargeable Li-ion Battery
(Optional)
Attach the battery base (PA-BB-002) to the machine. For more information
about attaching the battery base, see its instruction manual.
 Installing the Rechargeable Li-ion Battery
1.
Press and hold the (Power) button to turn the machine off.
2.
Open the battery cover on the bottom of the machine.
3.
Insert the battery into the battery compartment.
4.
Close the battery cover.
 Removing the Rechargeable Li-ion Battery
Press and hold the (Power) button to turn the machine off.
Remove the battery cover and the battery, and then reattach the battery
cover.
1
2
(Power) button is enabled.
 Charging the Rechargeable Li-ion Battery
NOTE
• Before use, fully charge the battery.
• Up to three hours may be needed to fully charge the battery.
1.
Make sure the battery is installed in the machine.
2.
Use the AC adapter and power supply cord to connect the machine to
an electrical socket.
Press the (Power) button to turn the machine on if it is not on already.
The (Battery) indicator lights in orange during charging, and it goes
off when the battery is fully charged.
1 AC adapter
2 Power supply cord
NOTE
Although the charging stops if the machine is used to print, feed, or
perform another operation, the charging will start again automatically
after the operation is finished if the charging is not completed.
 Stopping Rechargeable Li-ion Battery Charging
To stop the battery charging, disconnect the AC adapter.
Notes on Using the Rechargeable Li-ion Battery
 Before use, fully charge the battery. Do not use it until it is fully charged.
 The battery charging must take place in environments between 0°C and
40°C, otherwise the battery will not charge, and the
indicator will remain lit. If the charging stops because the environment
temperature is too low or too high, place the machine with a temperature
between 0°C and 40°C and try charging again.
 If the machine is used to print, feed, or perform another operation when
both the battery is installed and the AC adapter is connected, the
(Battery) indicator may turn off and charging may stop even if the
battery is not fully charged.
Rechargeable Li-ion Battery Characteristics
To ensure the highest performance and longest life from the battery:
 Do not use or store the battery in a location exposed to extreme high or
low temperatures as it may discharge more quickly. This may happen
when using a rechargeable Li-ion battery with a high charge (90%
charged or more) in a location exposed to high temperatures.
 Remove the battery when storing the machine for long periods of time.
 Store a battery with less than a 50% charge in a cool dry place out of
direct sunlight.
 Recharge the battery every six months if it is stored for long periods of
time.
 If you touch a part of the machine while the Li-ion battery is charging,
that part of the machine may feel warm. This is normal, and the machine
may be used safely. However, if the machine becomes extremely hot,
discontinue use.
1
2
(Battery)