Connecting The Power Supply - Brother PT-D800W User Manual

Setting Up the P-touch Labeling System

Connecting the Power Supply

Use the AD9100ESA (AC Adapter) for this P-touch labeling system. Connect the AC Adapter directly to the
P-touch labeling system.
a
Insert the plug on the AC Adapter Cord into the AC Adapter Outlet marked DC IN 24 V on the P-touch
labeling system.
b
Insert the plug on the Power Supply Cord into the AC Adapter.
1 AC Adapter
2 Power Supply Cord
c
Insert the power supply plug into a standard AC Power Outlet.
Important
• Turn off the P-touch labeling system before disconnecting the AC Adapter.
• Do not pull or bend the AC Adapter cord or Power Supply Cord.
• After the power supply plug is inserted into the AC Power Outlet, it may take a few seconds until the
(Power) Button is enabled.
Note
To safeguard and back up the P-touch labeling system memory, when the power supply is unplugged
Brother recommends leaving the rechargeable Li-ion batteries (optional: PA-BT-4000LI) installed in the
P-touch labeling system.
1
2
1
1
5