Installing The Paper Guide; Connecting To The Power Supply - Brother QL-500 User Manual

10
Getting started
3
Lift the label lever and then thread the
end of the DK Roll into the slot
immediately before the cutter.
When unable to thread the end of the DK
Roll into the slot, thread it as far as
possible, then lower the label lever and
close the cover. Press the ON/OFF button
to turn the QL-500/560 on, and then press
the FEED button to set the roll.
4
Lower the label lever and then close the DK
Roll compartment cover.

3 Installing the paper guide

Your QL-500/560 comes with a
paper guide that collects strips of
printed labels that have not been
cut off from the machine.
Attach the paper guide to the front of
the QL-500/560 as shown in the figure.
Remove the paper guide when printing
more than 10 labels continuously and
cutting each label automatically
(QL-560 only).

4 Connecting to the power supply

Connect the AC power cord to the QL-500/560 and
then plug the power supply cord into a standard
electrical socket.
Check that the electrical socket is 220 ~ 240 V before inserting
•
the plug.
Remove the power supply cord from the electrical socket after
•
you have finished using the QL-500/560.
Do not pull the cord when removing it from the electrical
•
socket. The wire in the cord may become damaged.
Paper guide