NETGEAR MS108EUP Hardware Installation Manual page 23

8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch MS108EUP
The screws and anchors are in the switch package.
4. Insert the anchors into the wall and tighten the screws with a No. 2 Phillips screwdriver.
Leave about ¼ inch (6 mm) of each screw protruding from the wall so that you can
insert the screws into the holes on the bottom of the switch.
5. Line up the holes on the bottom panel of the switch with the screws in the wall and
mount the switch to the wall.
You can mount the switch with the front panel facing down (the Ethernet cables will
be at the bottom, see the upper figure) or facing up (the Ethernet cables will be at
the top, see the lower figure).
Installation 23 Hardware Installation Guide