Wall-Mount The Switch Vertically; Mount The Switch To A Pole Or Another Surface - NETGEAR MS108EUP Hardware Installation Manual

8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch MS108EUP

Wall-mount the switch vertically

The bottom panel of the switch provides two VESA mount holes at an exact distance of
3.94 in. (100 mm), center-to-center, so that you can mount the switch vertically to a wall.
The switch ships with wall-mount screws and anchors that you can secure to a wall and
attach the switch to.
To mount the switch vertically to a wall:
1. Locate the two VESA mount holes on the bottom panel of the switch.
2. Mark the holes on the wall where you want to mount the switch.
The holes must be 3.94 in. (100 mm) apart, center-to-center.
3. Drill holes into the wall for four anchors in which you will insert M4 x L25 mm screws.
The screws and anchors are in the switch package.
4. Insert the anchors into the wall and tighten the screws with a No. 2 Phillips screwdriver.
Leave about ¼ inch (6 mm) of each screw protruding from the wall so that you can
insert the screws into the holes on the bottom of the switch.
5. Line up the holes on the bottom panel of the switch with the screws in the wall and
mount the switch to the wall.
You can mount the switch with the front panel facing left (the Ethernet cables will be
on the left, see the left figure) or facing right (the Ethernet cables will be on the right,
see the right figure).

Mount the switch to a pole or another surface

You can use an off-the-shelf 100 mm VESA standard mount to secure the switch to a
pole or another surface.
Installation 24 Hardware Installation Guide