Wipers And Washers - Honda CITY 2017 Owner's Manual

Wipers and Washers

■
Windscreen Wipers/Washers
Pull to
use
washer.
MIST
OFF
INT: Low speed with
intermittent
LO: Low speed wipe
HI: High speed wipe
*1: Models with the keyless access system have an ENGINE START/STOP button instead of an
ignition switch.
uuOperating the Switches Around the Steering WheeluWipers and Washers
The windscreen wipers and washers can be
used when the ignition switch is in ON
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain.
■
Washer
Sprays while you pull the lever towards you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windscreen,
then stop.
1Wipers and Washers
NOTICE
Do not use the wipers when the windscreen is dry.
( w *1 .
The windscreen will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windscreen, becoming stuck.
Operating the wipers in this condition may damage
the wipers. Use the demister to warm the
windscreen, then turn the wipers on.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor is equipped with a breaker that may
stop motor operation temporarily to prevent an
overload. Wiper operation will return to normal within a
few minutes, once the circuit has returned to normal.
If the wipers stop operating due to any obstacle such as
the build-up of snow, park the vehicle in a safe place.
Rotate the wiper switch to OFF, and turn the ignition
switch to ACCESSORY
remove the obstacle.
*1 or LOCK *1 , then
( q 0 (
157