Polaris RANGER 500 2017 Service Manual page 432

FINAL DRIVE
12. Thoroughly clean all parts. Inspect the bearing
surfaces of the output hub. Inspect the rollers
nicks, scratches and flat spots. Inspect the roll cage
o
for damage or cracks. The rollers must slide up
and down freely within the roller cage surfaces.
i
13. Inspect the ring gear
or damage. The surfaces should be free of nicks or
burrs.
14. Inspect roll cage (B) sliding surface. This surface
must be clean and free of nicks, burrs or scratches.
Inspect the H-springs, but do not remove them
from the roll cage.
8.26
a
for
for inconsistent wear patterns
15. Inspect the armature plate for a consistent wear
pattern. Uneven wear of the armature plate indicates
a warped plate, which may cause intermittent
operation.
NOTICE
See "FRONT GEARCASE DIAGNOSIS" later in this
chapter for more details.
16. Drill a hole in the input shaft seal
seal using a pry bar or seal puller.
9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual
d
and remove the
© Copyright Polaris Inc.