Table of Contents
Advertisement
30
Occupant safety
Restraint system functionality
When the ignition is switched on, a self-test is
performed, during which the 6 restraint sys‐
tem warning lamp lights up. It goes out no later
than a few seconds after the vehicle is started.
The components of the restraint system are then
functional.
Malfunctioning restraint system
A malfunction has occurred in the restraint sys‐
tem if:
the 6 restraint system warning lamp does
R
not light up when the ignition is switched on
the 6 restraint system warning lamp
R
lights up continuously or repeatedly during a
journey
& WARNING Risk of injury due to malfunc‐
tions in the restraint system
If the restraint system is malfunctioning,
restraint system components may be trig‐
gered unintentionally or may not deploy as
intended during an accident. This may affect
the seat belt tensioner or airbag, for exam‐
ple.
Have the restraint system checked and
#
repaired immediately at a qualified spe‐
cialist workshop.
Function of the restraint system in an acci‐
dent
How the restraint system works is determined by
the severity of the impact detected and the type
of accident anticipated:
Frontal impact
R
Rear impact
R
Side impact
R
Rollover
R
The activation thresholds for the components of
the restraint system are determined based on
the evaluation of the sensor values measured at
various points in the vehicle. This process is pre-
emptive in nature. The triggering/deployment of
the components of the restraint system must
take place in good time at the start of the colli‐
sion.
Factors which can only be seen and measured
after a collision has occurred do not play a deci‐
sive role in the deployment of an airbag. Nor do
they provide an indication of airbag deployment.
The vehicle may be deformed significantly with‐
out an airbag being deployed. This is the case if
only parts which are relatively easily deformed
are affected and the rate of vehicle deceleration
is not high. Conversely, an airbag may be
deployed even though the vehicle suffers only
minor deformation. If very rigid vehicle parts
such as longitudinal members are hit, for exam‐
ple, this may result in sufficiently high levels of
vehicle deceleration.
Advertisement
Table of Contents
