Table of Contents
Advertisement
ing condition (
page 287). Observe the
/
notes on tyre temperature (
%
The values displayed in the multifunction dis‐
play may deviate from those of the tyre pres‐
sure gauge as they refer to sea level. At high
altitudes, the tyre pressure values indicated
by a pressure gauge are higher than those
shown by the on-board computer. In this
case, do not reduce the tyre pressure.
Make sure to observe the following further rela‐
ted subject:
Notes on tyre pressure (
/
R
Restarting the tyre pressure monitoring sys‐
tem
Requirements:
The recommended tyre pressure is correctly
R
set for the respective operating status on
each of the four wheels (
/
Restart the tyre pressure monitoring system in
the following situations:
The tyre pressure has changed.
R
The wheels or tyres have been changed or
R
page 286).
newly fitted.
/
On-board computer:
Service
4
Swipe downwards on Touch Control on the
#
left-hand side of the steering wheel.
The
Use current tyre pressures as new refer-
ence values?
function display.
To begin restart, press Touch Control on the
#
left-hand side of the steering wheel.
page 286)
The
Tyre press. monitor restarted
shown in the multifunction display.
Current warning messages are deleted and
the yellow h warning lamp goes out.
After you have been driving for a few
minutes, the system checks whether the cur‐
page 286).
rent tyre pressures are within the specified
range. The current tyre pressures are then
accepted as reference values and monitored.
Make sure to observe the following further rela‐
ted subject:
Notes on tyre pressure (
R
Tyres
5
message is shown in the multi‐
message is
page 286)
/
Wheels and tyres 289
Radio equipment approval of the tyre pres‐
sure monitoring system
Radio equipment approval numbers
Missing values were not available at the time of
going to press.
Advertisement
Table of Contents
