Table of Contents
Advertisement
Release the previously pressed button.
#
Indicator lamp
1
continues to flash yellow.
Point remote control
5
from a distance of
#
1 cm to 8 cm towards buttons 2,
Press and hold button
6
of remote control
#
5
until:
Indicator lamp
1
lights up green contin‐
R
uously. Programming is complete.
Indicator lamp
1
flashes green. Pro‐
R
gramming was successful. Additionally,
synchronisation of the rolling code with
the door system must also be carried out.
If indicator lamp
1
does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
%
The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronising the rolling code
Requirements:
The door system uses a rolling code.
R
The vehicle must be within range of the
R
garage door or door drive.
The vehicle as well as persons and objects,
R
3
or 4.
are located outside the range of movement
of the door.
Driving and parking 129
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 2,
#
or
4
repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
%
Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
3
Advertisement
Table of Contents
