To Close The Indoor Unit; Mounting The Indoor Unit; To Install The Indoor Unit - Daikin Altherma 3 R W Installation Manual

4 Unit installation
2×
4 If you have to do work behind the user interface panel or upload
new software into the user interface, open the user interface
panel.
2×
1
5 Optional: Remove the user interface panel.
NOTICE
If you remove the user interface panel, also disconnect the
cables from the back of the user interface panel to prevent
damage.
X 1 A
1
2
3
X 1 4 Y
2
4.2.2

To close the indoor unit

1 Reinstall the user interface panel.
2 Reinstall the switch box cover and close the switch box.
3 Reinstall the front panel.
NOTICE
When closing the indoor unit cover, make sure that the
tightening torque does NOT exceed 4.1 N•m.
Installation manual
14
2
3
2
4.3

Mounting the indoor unit

4.3.1

To install the indoor unit

1 Fix the wall bracket (accessory) to the wall (level) with 2×
Ø8 mm bolts.
a Optional: If you want to fix the unit to the wall from inside
the unit, provide an additional screw plug.
2 Lift the unit.
11 kW: 52.5 kg
16 kW: 54.5 kg
3 Attach the unit to the wall bracket:
▪ Tilt the top of the unit against the wall at the position of the
wall bracket.
▪ Slide the bracket on the back of the unit over the wall
bracket. Make sure the unit is fixed properly.
4 Optional: If you want to fix the unit to the wall from inside the
unit:
a
2×
(mm) (mm)
EBBH/X11+16DF
Daikin Altherma 3 R W
4P643600-1B – 2021.10