Recording An Md Right Away - Sony MZ-N1 Operating Instructions Manual

• Do not try to recharge the battery.
• When the recorder is not be used for a long
time, be sure to remove the battery.
• If a battery leak should develop, carefully
and thoroughly wipe away battery fluid
from the battery compartment before
inserting new ones.
BMD recording

Recording an MD right away!

(Synchro-recording)
See the illustrations in Japanese text (pages 19
and 20).
This section explains the basic procedure
for making digital recordings using an
optical cable connected to a CD player, BS
tuner or other digital equipment. The
recorder starts and stops recording in sync
with the source sound. Track marks are
added whenever they appear in the sound
source. It is recommended to use the AC
power adaptor when recording.
To record from a cassette deck, radio, etc.
t"Recording in analog (analog recording)"
(page 101)
To record using a group mode t "Recording
tracks using the group function (Group Mode
Recording)" (page 102)
1 Insert an MD.
1 Slide OPEN to open the lid.
2 Insert an MD with the label side
facing front, and press the lid to close.
Insert an recordable MD when recording.
2 Make connections. (Insert the cables
firmly and completely into the
appropriate jacks.)
1 Connect the LINE IN (OPT) jack of
recorder to the digital (optical) out jacks
of the source with a optical cable.
The recorder switches to digital input
automatically.
2 Connect the DC IN 3V jack of the
recorder to a wall outlet with the AC
power adaptor.
When the recorder has different sound
sources connected at the same time, the
recorder switches to the digital,
microphone, or analog input in this
order of priority.
3 Record an MD.
1 While the recorder is stopped, press
the jog dial.
2 Turn the jog dial until "SYNC REC"
flashes in the display, and then press
to enter.
3 Turn the jog dial until "SYNC ON"
flashes in the display, and then press
to enter.
4 Press and slide REC to the right.
"REC" and REC LED on the REC
switch light up and recording starts.
5 Play the CD or tape you want to
record.
To stop recording, flip the control bar
towards x.
After you flip the bar towards x to stop, the
recorder will automatically turn off in about
10 seconds (when using batteries) or about 3
minutes (when using AC power adaptor).
Note
If you record on a previously recorded disc,
the recorder is factory set to overwrite the
entire contents of the disc. If you want the
recording to start after the existing contents,
do the procedure "Recording without
overwriting existing material" (page 103)
before step 3, "Record an MD" (this page).
To Do this
Record from If "REC-Posi" is set to
the end of the "From Here", press END
current SEARCH, and then press
contents 1) and slide REC to the right.
If "REC-Posi" is set to
"From End", press and
slide REC to the right.
Record over Press N, >, or . to
partway find the start point of
through the recording and flip the bar
previous towards x to stop. Then
recording press and slide REC to the
right.
Pause Flip the bar towards X.
Flip the bartowards X again
to resume recording.
Remove the MD Flip the bartowards x,
then slide OPEN to open
the lid.
1)
If "REC-Posi" is set to "From End",
recording operations will always start from
the end of the previously recorded material
without pressing END SEARCH.
2)
3)
97