Labeling Recordings - Sony MZ-N1 Operating Instructions Manual

The number of titles that can be stored on a
disc depends on the number of characters that
are input for track names, group names, and
disc name.
About the character palette
During operations on the recorder, characters
can be selected from the character palette in
the display.
Since only a part of the character palette is
visible on the display, use the control bar to
move the cursor and enter characters.
For configulation of the character palette,
see page 48 in Japanese text.
Notes
• "NAME FULL" appears when you try to
enter more than 1,700 characters on a disc.
Enter a shorter name for the track, group, or
disc, or set the "LP Stamp" setting to "Stamp
OFF" so that "LP:" is not be added at the
beginning of the track name.
• When labeling a disc which has been
recorded using the group function, make
sure group mode is on in order to prevent
the group management information from
being overwitten by mistake.
• If you enter the symbol "//" between the
characters in disc names such as "abc//def,"
you may be unable to use the group function.

Labeling recordings

On the recorder
1 Insert a disc and do the followings.
To label a track:
Start playing or recording the track you
want to label, and then label the track
while the recorder is playing or
recording.
To label a group:
Turn the group mode on (page 102) and
start playing or recording the track
within the group you want to label, and
then label the group while the recorder
is playing or recording.
To label a disc:
Label a disc while the recorder is
stopped or recording.
If you label a disc with group settings,
turn the group mode on (page 102).
2 While the recorder is stopped, press the
jog dial.
3 Turn the jog dial until "EDIT" flashes in
the display, and then press to enter.
110
4 Turn the dial until the following item
appears in the display, and then press to
enter.
When labeling a track: "
When labeling a group: "
When labeling a disc: "
The cursor flashes in the letter input area
and the track, group, or disc is ready to
be labeled.
5 Flip the bar towards x.
The cursor shifts from the letter input
area to the character palette.
6 Select a letter with the control bar and
press N to enter.
The selected letter appears in the letter
input area and the cursor moves to the
next input position.
The buttons used for character input and
their functions are listed below.
Functions 1)
To move the cursor in
the character palette.
To select a character in
the letter input area.
To enter a letter.
To move the cursor from
the letter input area to
the character palette.
To move the cursor
from the character
palette to the letter
input area.
To enter a name.
To insert a blank space
before the cursor in the
letter input area.
To delete a letter in the
letter input area.
To display ":", "–" and
"/" repeatedly at the
input position in the
letter input area.
: Name"
: Name"
: Name"
Operations
Control bar.
Turn the jog dial
(move the cursor
upward or
2)
downward) .
Turn the jog dial.
Press N.
Press the jog dial.
Flip the bar
towards x.
Press CANCEL.
Press N or the
jog dial for 2
second or more.
Press VOLUME +.
Press VOLUME –.
Press T MARK.