Recording An Md Right Away - Sony MZ-R50 Operating Instructions Manual

zMD recording

Recording an MD right away!

See the illustrations in the Japanese text
(page 10 to 11).
Use a line cable (not supplied) to hook up
an analog source. The source sound of CDs
or tapes will be sent as an analog signal
and recorded digitally. If you want to
record programs from digital equipments
or a microphone, see "Various ways of
recording".
Premastered MDs cannot be recorded over.
1 Make connections.
1 Connect the LINE IN (OPTICAL)
jack of recorder to the LINE OUT
R(red)/L (white) jacks of the
source with a line cable.
The recorder switches to analog
input automatically.
2 Connect the DC IN 6V jack of the
recorder to a wall outlet with the
supplied AC power adaptor.
When the recorder has different sound
sources connected at the same time,
the recorder switches to the digital,
microphone, or analog input in this
order of priority.
2 Insert a recordable MD.
1 Slide the OPEN switch and
open the lid.
2 Insert a recordable MD with
the label side facing up, and
press the lid down to close.
Select recording start point.
3
If you want to add a recording to the
end of the previous recording, press
END SEARCH button.
(If you want to start recording from the
beginning, skip this step).
4 Start recording.
1 Press and slide the REC switch to
the right.
"REC" lights up and recording
starts .
2 Play the sound source.
The level of the recorded sound is
adjusted automatically.
50
To stop recording, press p.
Do not move or jog the recorder or disconnect
the power source while the "Data Save" or
"Toc Edit" indication is flashing in the
display.
To
Pause
Record over
partway through
the previous
recording
Remove the MD
1)
A new track mark is added at the point
where you pressed P, and the recording
will be marked with the new track number
when you resume recording.
2)
Once you open the lid, the point to start
recording will change to the beginning of the
first track. When recording on a recorded
MD, check the point to start recording on the
display.
If the recording does not start
Make sure the MD is not record-protected.
If the tab at the side of the MD is open,
slide it back so the tab is visible.
Press
P. 1)
Press P again to
resume recording.
(, + or = to
find the start point of
recording and press
p to stop. Then slide
the REC switch.
p, then slide the
OPEN switch and
2)
open the lid.