Adapting Attachments Requiring 12V Electrical; Power - New Holland L465 Repair Manual

SECTION 1 - GENERAL INFORMATION
ADAPTING ATTACHMENTS REQUIRING
12V ELECTRICAL POWER
There are important rules that must be followed
when adapting attachments that require 12 volt
electrical power. Proper wiring of electrical
devices and power and ground connections is
very important to prevent other electrical
component damage. Attaching electrical
connections to locations other than
recommended may allow electric current to feed
back through the EiC board, creating false EiC
board readings and warnings, or causing EiC
board damage or failure.
1.
ALWAYS
FOLLOW the instructions for New
Holland kit installation to ensure proper
function and operation.
2. NEVER CONNECT an electrical device to
any wires, fuses, switches or grounds inside
the cab area. This includes any terminals of
the ignition switch, fuse panel, or ground
terminal.
3. NEVER INSTALL an electrical device, music
radio, two-way radio, or unapproved New
Holland attachment into the cab area.
4. ONLY USE the 12-volt accessory power
outlet for attachments requiring less than
1 O amps. The accessory outlet is connected
to the engine fuse/relay panel and protected
with a 15 amp fuse.
5.
ALWAYS
CONNECT new electrical
attachments to the engine fuse/relay panel,
1, and connect the grounds to the engine bell
housing. USE ONLY vacant connections and
fuses not in use for specified attachments.
6. PLEASE REFER to Service Bulletin 11 /95-14
for more detailed information about higher
amperage requirements and making
electrical connections.
.....-~===-:::.----==~~L__-.f!.
f7)
1-28
Figure 1-31
Figure 1-32