Adjusting And Replacing The Cutter - Canon W7200 User Manual

Adjusting and Replacing the Cutter

Note
1
2
7-40
Troubleshooting
Follow the procedure below to adjust the position of the cutter when the
cutting blade becomes dull and can no longer cut efficiently.
The printer cutter has three positions. Adjusting the cutter to another setting
positions a new part of the blade for cutting. After the cutting blade becomes
dull at the third position, the cutter must be replaced.
z If the notch is already as position 3, obtain a new cutter blade for replacement.
If the printer is off, press the Power button to switch the printer on.
Paper Source
After a few seconds "Online" is displayed in the operation panel and the
Online lamp lights.
Press the Online button to display "Offline".
Paper Source
Data Message
Roll Media
Cut Sheet
Cancel nter
Data Message
Roll Media
Cut Sheet
Cancel nter
Power
Online
Power
Online