Stihl HLE 71 Instruction Manual page 22

English
bent or warped), correctly mounted and thor‐
oughly sprayed with STIHL resin solvent (lubri‐
cant)
– For machines with adjustable cutter bar: The
adjustment mechanism must be snapped into
the start position
– For machines with a defined transport position
(cutter bar folded against the shaft): Never
start the machine in the transport position
– Never attempt to modify the controls or safety
devices
– Keep the handles dry and clean – free from oil
and dirt – this is important for safe control of
the machine
– Adjust carrying harness and handles in
accordance with body height. Observe the
chapter "Fitting the Harness"
To reduce the risk of personal injury, do not
operate your power tool if it is damaged or not
properly assembled!
To prepare for emergencies when using a har‐
ness: Practice setting down the machine quickly.
To avoid damage, do not throw the machine to
the ground when practicing.
To reduce the risk of electric shock:
– Always connect the engine analyzer to a prop‐
erly installed wall outlet.
– Any extension cords used must comply with
the specifications for the particular application
– Check that the insulation of the power cord,
extension cord, plug and coupling is in good
condition
2.4 Holding and guiding the
machine
Always hold the unit firmly with both hands on
the handles.
Keep your right hand on the control handle and
your left hand on the loop handle on the shaft –
this applies to left-handed people as well. Wrap
your fingers and thumbs around the handles.
22
2 Safety Precautions and Working Techniques
Make sure you always have a good footing and
hold the machine so that the cutting blades are
always facing away from your body.
Some versions of the machine can be carried on
a belt to relieve the weight on the operator's
arms.
2.5 While working
In case of imminent danger or in an emergency,
switch off the motor immediately – release the
trigger switch and starting lockout.
Keep away from power cables – dan‐
ger of electrocution!
5m (17ft)
To reduce the risk of injury from moving blades
or falling cuttings, do not allow bystanders within
5 meters of your own position. This distance
must also be maintained in relation to objects
(vehicles, window panes) – risk of property dam‐
age!
Watch the cutting blades at all times – do not cut
areas of the hedge that you cannot see.
Be extremely careful when cutting tall hedges,
check the other side of the hedge before starting
work.
The drive motor is not waterproof. To
reduce the risk of a short circuit or
electrocution, never work with the
power tool in the rain or in wet or very
damp locations.
Do not leave the power tool outdoors in the rain.
Take special care in slippery conditions – damp,
snow, ice, on slopes or uneven ground!
Clear away fallen branches, scrub and cuttings.
Watch out for obstacles: tree stumps, roots – risk
of tripping or stumbling!
Make sure you always have good balance and
secure footing.
0458-277-9621-B