Stihl HLE 71 Instruction Manual page 21

2 Safety Precautions and Working Techniques
Unsuitable extension cords may be dangerous.
When using extension cords, ensure that the
minimum conductor cross-sections are main‐
tained (refer to the chapter entitled "Connecting
the machine to the power supply").
The connector and coupling of the extension
cord must be waterproof or routed in such a way
that they cannot come into contact with water.
Only use cutting blades and accessories that are
explicitly approved for this power tool by STIHL
or are technically identical. If you have any ques‐
tions in this respect, consult your dealer. Use
only high quality parts and accessories. in order
to avoid the risk of accidents and damage to the
machine.
STIHL recommends the use of original STIHL
tools and accessories. They are specifically
designed to match the product and meet your
performance requirements.
Never attempt to modify your power tool in any
way since this may increase the risk of personal
injury. STIHL excludes all liability for personal
injury and damage to property caused while
using unauthorized attachments.
Do not use a high-pressure washer to clean the
power tool. The solid jet of water may damage
parts of the unit.
Do not spray the power tool with water.
2.1 Clothing and equipment
Wear proper protective clothing and equipment.
Clothing must be sturdy but allow
complete freedom of movement.
Wear close-fitting clothes such as a
boiler suit, not a loose jacket.
Do not wear clothing which could become trap‐
ped in wood, brush or moving parts of the
machine. Do not wear a scarf, necktie or jewelry.
Tie up and confine long hair above your should‐
ers.
Wear safety boots with steel toe caps
and non-slip soles.
WARNING
To reduce the risk of eye injuries,
wear close-fitting safety glasses in
accordance with European Standard
EN 166. Make sure the safety
glasses are a snug fit.
0458-277-9621-B
Wear "personal" sound protection, e.g. ear
defenders.
Wear a safety hard hat where there is a danger
of head injuries from falling objects.
Wear sturdy protective gloves made
of a resistant material (e.g. leather).
STIHL can supply a comprehensive range of per‐
sonal protective equipment.
2.2 Transporting the machine
Always switch off the power tool and unplug it
from the power supply.
Always fit the scabbard over the blades before
transporting the machine even for short distan‐
ces.
For machines with adjustable cutter bar: Engage
the cutter bar.
For machines with a defined transport position:
Bring the cutter bar in transport position and
have it engaged.
Carry the power tool properly balanced by the
shaft – cutting blades behind you.
To reduce the risk of burn injury, do
not touch the gear housing!
Transporting by vehicle: Properly secure the
power tool to prevent turnover and damage.
2.3 Before Starting Work
Check that your power tool is properly assem‐
bled and in good condition – refer to appropriate
chapters in the User Manual:
– Voltage and frequency of the machine (see
rating plate) and the voltage and frequency of
your power supply must be the same.
– Examine the connecting cord, power plug and
extension cord for damage. Damaged cords,
couplings and plugs or connecting cords that
do not comply with the regulations must not be
used
– Extension cord sockets must be splash-proof
– To reduce the risk of stumbling, position and
mark the connecting cord so that it cannot be
damaged or endanger others
– Starting lockout lever and trigger switch must
move freely – the switch must return to the idle
position when it is released.
– Cutting blades must be properly tightened and
in safe operating condition (clean, sharp, not
English
21