Receiving A Dab Service (Uk Model Only) - Sony Giga Juke NAS-50HDE Operating Instructions Manual

Tips
 If you experience noise in an FM stereo broadcast,
enter the Option menu and select [Setting] – [FM
mode] – [Monaural]. The reception will no longer
be stereo, but it will be clearer. To change back to
stereo reception, do the same procedure and select
[Auto stereo].
 For better broadcast reception, try changing the
direction or location of the antenna. For example,
position the antenna near or outside a window. If
the reception does not improve, it is recommended
to connect a commercially available external
antenna.

Receiving a DAB service (UK model only)

Before you can receive DAB services,
the broadcast components (service
components) must first be registered
by conducting a DAB Auto Scan (see
"Performing DAB Auto Scan" on page 23).
Press DAB, or enter the Function menu
and select [DAB].
The DAB main display appears and the
unit starts receiving the services.
Other operations
To
Select different
services
Switch between
the primary
and secondary
components

GB
Do the following:
Press / repeatedly
to select the desired service.
Press  to display the
service component list, press
/ to select the desired
service, and then press
ENTER.
Press the corresponding
numeric button to select the
service number (or preset
number) of the desired
service.
Press /.
To Do the following:
Switch between Enter the Option menu and
"auto tuning" select [Mode switch].
and "preset
tuning"*
* When you switch from "auto tuning" to "preset
tuning":
 The unit changes to the preset tuning display
and begins receiving the service for the last
preset number used.
 "No preset" appears in the preset tuning display
if the last preset number used was cleared.
About the DAB reception display
Ensemble Label
Name of service
Dynamic Label Segment
Service Label and frequency
About DAB service component list
Service number