Sony Giga Juke NAS-50HDE Operating Instructions Manual page 104

YEAR channel does not work correctly.
 O nly tracks with information on its
release year will be assembled into the
YEAR channel.
 Th e year indicated for a track assembled
in the YEAR channel may not necessarily
be the year of its first release. This
is because the information used
corresponds with the CD on which the
track or album is contained.
Timer
The Recording Timer does not work.
 S et the date and time correctly (pages 18
and 70).
 A power failure occurred while the timer
setting was in standby mode or the power
cord was disconnected.
 Th e unit is being subjected to shocks
or vibrations. Place the unit at a stable
location.
Although the Wake up Timer has been
set, the unit does not start playback at
the specified time.
 S et the date and time correctly (pages 18
and 69).
 A power failure occurred while the timer
setting was in standby mode or the power
cord was disconnected.
 Th e unit is being subjected to shocks
or vibrations. Place the unit at a stable
location.
The contents recorded by the
Recording Timer is not complete. Some
of the material at the beginning or in
the middle are missing.
 S et the date and time correctly (pages 18
and 70).
 A power failure occurred while the timer
setting was in standby mode or the power
cord was disconnected.
10
GB
 Y ou performed an operation, such as an
editing operation, or you backed up the
data shortly before the Recording Timer
was activated.
 Th e unit was subjected to shocks or
vibrations. Place the unit at a stable
location.
Network Media
You cannot connect to the server
(the message "Cannot access server."
appears).
 M ake sure the network cable is
connected.
 I f a hub or a router with a built-in hub
is being used, make sure that it is turned
on.
 M ake sure the server is turned on.
 M ake sure that the IP address of this unit
is correctly obtained.
 I f [DHCP] is set to [All auto] and the
IP address is obtained correctly, the IP
address will appear in the display (page
92). If the IP address does not appear,
check the following items.
Make sure the hub or broadband

router is turned on. (Refer to the
operating manuals supplied with the
equipments being used.)
Make sure the broadband router is

turned on before you turn on the unit.
Make sure network cables are being

used to connect the unit, hub, or
broadband router (pages 87 to 89).
Make sure that the method of

obtaining the IP address is correct for
your network environment (page 92).