Nikon SMZ800N Instruction Manual page 90

2) Fill in the gap between the bottom part and the
barrier filter with adhesive.
(3) Bond to attach the barrier filter to the top part.
1) Push the barrier filter into the position shown in
the figure of the top part until it hits the bonding
surface. Observe the manufacturer's
instructions for the orientation of the barrier
filter.
2) Fill in the gap between the top part and the
barrier filter with adhesive.
(4) Bond to attach the excitation filter.
1) Push the excitation filter into the position
shown in the figure of the bottom part until it
hits the bonding surface. Observe the
manufacturer's instructions for the orientation
of the excitation filter.
2) Fill in the four bonding positions of the bottom
part with adhesive to bond the excitation filter
to the bottom part.
(5) Bond to attach the dichroic mirror.
1) Place the dichroic mirror so that its evaporated
surface contacts the bonding surface and the
side touches the abutting surface.
2) Place the dichroic mirror at the center of the
bonding surface and place adhesive at the four
bonding positions shown in the figure.
Adhesive application
 Make sure that the adhesive does not seep in
between the dichroic mirror and the bonding
surface.
 Adhesive must not leak from the bottom part.
Chapter 5
Assembly
76
Bond along the
circumference.
Barrier filter bonding - 1
Barrier filter setting - 2
Bond along the
circumference.
Barrier filter bonding - 2
Excitation filter setting
Bond four positions.
Excitation filter setting
Dichroic mirror setting
Adhesive at the four positions
Dichroic mirror bonding
DM
Adhesive
Bottom part