Inactive Standby; Factory Reset - PURE Evoke Series User Manual

Set time/date
This option is for manually setting the time and date displayed. The date displays as DD-
MM-YYYY, with the first value, DD, active (flashing). Adjust each value using the select
control button and press Select to confirm. The next value then becomes active and
flashes. The time values follow and are set in the same way.
Auto-update
Auto-update works with data sent over DAB, FM or network. The clock is only updated
when in a corresponding mode, so it is best to select a mode you use regularly.
DAB and FM use time signals broadcast with radio transmissions.
Network uses a time signal sent from the Internet radio portal when in any network-
connected mode.
Note that if you are updating the time from DAB or FM, the Daylight savings option has
no effect on the clock's time.
Your Evoke will auto-update from the selected Mode when time information is available.

Inactive Standby

With this option, the radio will go into standby automatically, when there was no interaction
with the radio within a certain time span. This should avoid the radio playing endlessly, when
you leave the house, while it's still playing.
Timeout - Off | 2 hours | 4 hours | 5 hours | 6 hours
Language
The default language is English. To change, select Menu > System settings > Language >then
select your language.

Factory reset

A factory reset clears all user defined settings, replacing them with the original default values, so
time/date,preferences/ settings and DAB station list are all lost.
If you select Factory reset, you are asked to confirm by selecting "Yes".
Backlight
You Evoke has a backlight with three brightness settings, and adjustable timeout (this is the time
delay, in seconds, after which the display switches to the Dim level when in Standby).
There are three settings:
Timeout - Light On | 10 | 20 | 30 | 45 | 60 | 90 | 120 | 180 sec
On level - High | Mid | Low
Dim level - Mid | Low
Note: the dim option only affects the brightness level of your Evoke being in the Standby state.
Light Ring
The brightness of the Light Ring under the volume dial can be adjusted.
There are three settings to choose from:
Brightness - High | Low | Off
1. Select Update from DAB, Update from FM, Update from Network or No update.
2. If you are updating from the network, set your time zone.
3. If your country uses daylight saving, the automatically updated time from the
network may be wrong by one hour. When daylight savings are in effect (during
the summer), turn on the Daylight savings option to rectify this.