PURE Evoke Series User Manual page 14

Now playing information
While a station is playing, the screen shows its name and DLS (Dynamic Label Segment)
information broadcast by the station such as programme name, track title and contact
details.
Other settings
Dynamic range compression (DRC)
FM
To enter FM mode: press Source and tap Source until FM radio is highlighted. Press Select to activate.
You can also use the Navigation Arrows to select your source
Selecting stations
The first time you select FM radio, your Evoke is set to the lowest frequency in the FM
band. On subsequent selections the last used frequency/station is displayed.
To scan for a station in FM mode press and hold the skip forward, skip back button or
the Navigation Arrows up and down arrows. Your Evoke scans through the FM band
frequencies, showing the current frequency on the screen display.
Alternatively, you can short press the skip forward, skip forward, skip back button or the
Navigation Arrows up and down arrows to tune in 50 kHz steps.
Now playing information
While FM radio is playing, the screen shows its frequency, or if RDS information is
available, station name and any further RadioText' information. If no information is
available, just the frequency and a No RadioText message is shown.
To view further information about the broadcast long press the Right/Info button. Each
time you long press the Right/Info button, the next set of information is displayed,
cycling through:
Settings
Scan settings
Slideshow
The normal now playing screen shows a thumbnail of the currently
available slideshow image. (If no slideshow image is available a default
DAB thumbnail image is displayed).
To view further information long press the Right/Info button.
Each time you press Info, the next set of information is displayed, cycling
through: DLS text, DL Plus information (this is only displayed if broadcast
by the station), programme type, ensemble name, channel number/
frequency, signal strength, Bit rate and date.
This function reduces the difference between the loudest and quietest audio
being broadcast.Effectively, this makes quiet sounds comparatively louder, and
loud sounds quieter.
Select Menu > DRC > The options available are: DRC high | low | off.
RDS Radio text
Programme type
Frequency
Date
By default, FM scans stop only at stations with good signal strength. To change
the scan settings, to stop at all stations select Menu > Scan setting to display the
option of scanning for 'Strong stations only?' and then select 'No' .
This may include poor quality audio from weak stations.