Setting The Display Language - SMA SUNNY BOY 8000TL-US Installation Manual

SMA America, LLC
PV overvoltage
(Yellow LED flashes 4 times quickly in succession)
NOTICE
Excessive DC voltage can destroy the Sunny Boy.
• Open all AC and DC circuit breakers or load-disconnecting switches.
Check DC voltage:
• Greater than 600 V: Contact the planner/installer of the PV generator for assistance.
• Lower than 600 V: Reconnect the Sunny Boy to the PV generator as described in section
6.6 "DC connection" (page 37).
If the message occurs again, disconnect the Sunny boy again and contact SMA America (see section
14 "Contact" (page 71)).
7.3 Setting the display language
You can set the language of the display using the switches on the underside of the display assemblies
inside the Sunny Boy.
Proceed as follows:
1. Open the Sunny Boy as described in section 8.1 "Opening the Sunny Boy" (page 48).
2. Set the switches for the required language, as shown below.
Language
German
English
French
Spanish
3. Close the Sunny Boy as described in section
8.2 "Closing the Sunny Boy" (page 49).
☑ The display language is set.
Installation Guide
Switch S2 Switch S1
B B
B A
A B
A A
Commissioning
SB8-10TL-IUS103811 47