Table of Contents
Advertisement
SMA America, LLC
5.4 Mounting the SMA DC Disconnect
Dimensions of the SMA DC Disconnect
Attach the SMA DC Disconnect to the two lower holes of the wall-mounting bracket, using two screws
and washers provided.
1. Place the screws and the washers in the holes in the
fastening tabs on the DC Disconnect. The teeth on
the washers must lie against the fastening tabs of
the DC Disconnect.
2. Place the SMA DC Disconnect against the wall
mounting bracket.
3. Tighten the screws with 44 in-lbs (5 Nm) torque.
☑ The SMA DC Disconnect is mounted.
Installation Guide
SB8-10TL-IUS103811
Mounting
25
Advertisement
Table of Contents
