Mounting The Wall Mounting Bracket - SMA SUNNY BOY 8000TL-US Installation Manual

SMA America, LLC
5.3.2 Mounting the wall mounting bracket
1. Position the wall-mounting bracket against the wall where you intend to mount the Sunny Boy.
Try to mount the Sunny Boy with the display at eye-level.
2. Place a level on the top edge of the bracket. Adjust the position until it is leveled. The bottom of
the bracket will be the approximate location of the bottom of the inverter.
DANGER
Risk of electric shock by drilling into power cables.
Death or serious injuries will result.
• Before drilling, check installation location for power cables.
CAUTION
Falling of the Sunny Boy may cause injuries.
Crushing of body parts will result.
• Ensure that there are studs in the wall where you intend to drill holes.
3. Use the wall-mounting bracket as a template. Mark the wall through at least three holes in
horizontal or vertical position of the bracket (see chapter 5.3.1 "Possibilities for mounting the
wall mounting bracket" (page 22)).
4. Remove the bracket and drill holes at the marks.
5. Insert wall anchors into the drill holes.
CAUTION
Falling of the Sunny Boy may cause injuries.
Crushing of body parts will result.
• Do not use molly or toggle bolts to mount the Sunny Boy to sheet rock or panelling.
Installation Guide SB8-10TL-IUS103811
Mounting
23