Table of Contents
Advertisement
3 OPERATOR VIEWS
3.1 View Set Points
-----
VIEW SETPOINTS
4. 2 0
Sen. A
10. 0 0
mg/l C
A1: Setpoint
Sen. B
10. 2 5
mg/l C
A2: Setpoint
Sen. B
3. 5 00
mg/l C
A3: Setpoint
VIEW SETPOINTS
View Set Points
This page shows alarm set points. The value of each of the set points is shown, together
with the name of the parameter it's assigned to.
Alarm assignments, set point values and relay/LED actions are programmable – see
Section 5.4. Those shown in the following frames are examples only.
Alarm 1 Set Point
Alarm set point in inferred units, e.g.
in Section 5.3. The units displayed alternate between the inferred units selected (see
Section 5.3) and the alarm assignment indication (
only]) – see Section 5.4.
Alarm set point in units selected for display – see
Alarm 2 Set Point
Alarm set point assignment – see Section 5.4.
Alarm set point in units selected for display – see
Note.
for Sensor B (dual input monitors only) set to
Inferred Units
Alarm 3 Set Point
See Section 3.2.
VIEW OUTPUTS
See Section 4.2.
SENSOR CAL
. For units available, refer to
Colour (H)
[or
Sen. A
Sen. B
Displayed Units
Displayed Units
Inferred Units
– dual input monitors
in Section 5.3.
in Section 5.3.
–see Section 5.3.
None
9
Advertisement
Table of Contents
