Installation And Operation; Installing The Boards Into The Powercage Enclosure - Extron electronics PowerCage MTP AV Series User Manual

Installation and
Operation
This section describes the installation and operation of the PowerCage MTP T AV and
MTP R AV, including:
•
•
•
•

Installing the Boards into the PowerCage Enclosure

Up to 16 single slot or 8 dual slot input/output boards can be inserted into the PowerCage
enclosure. All PowerCage MTP AV transmitters and receivers are all single slot boards.
NOTES: The boards are hot-swappable; they can be installed or removed without
1.
2.
Installing the Boards into the PowerCage Enclosure
Connections, LEDs, and Encoders
PowerCage Front Panel Port, Control, and Indicators
Operation
turning off or disconnecting the power to the PowerCage enclosure.
Use ESD precautions when installing a board to avoid damaging the
board. Keep the board in the anti-static bag until needed. Use proper
grounding techniques during installation.
Where applicable, remove as many blank plates or previously installed boards from the
rear of the PowerCage as necessary for the number of new boards to be installed.
Hold the board with the signal connectors towards you and the LED at the top, and
align the top and bottom grooves of the board with the slide posts in the selected
enclosure slot. See the example in figure 1.
Power
Supply
C
LI ST
8
77 1T
N 15
I.T
/6 0H z
50
.
0- 24 0V M AX
10 5A
Figure 1. Inserting Boards into the PowerCage Enclosure
PowerCage MTP T AV and PowerCage MTP R AV • Installation and Operation
16 Available Single Board Slots or
8 Double Board Slots
ag e
rC
we R AV
Po M TP
e
C ag D I
w er -S
H D
Po
X 3G
FO
e
C ag B
w er R G
R X
Po
X 4G
FO
Align board and
slide into slot.
U S
ED
23
.E .
Screws
(2 per board)
e
C ag R G B
w er
Po R X
X 4G
FO
3