Installation and
Operation
This section contains information for mounting, connecting, wiring, and operating the
DTP2 T 202 FB switching transmitter. Topics in this section include:
•
•
•
•
•
•
•
Installation Overview
The DTP2 T 202 FB is to be installed in an Ackermann GB3 (OBO Bettermann), MK Electric
CableLink Plus Modular, MK Electric CableLink Plus Single Pan, Electraplan, or PUK floor box.
CAUTION: Failure to check the items listed below may result in personal injury or
ATTENTION : La non-vérification des éléments listés ci-dessous peut provoquer des
1.
2.
3.
4.
5.
Installation Overview
Adapter Plates
Side Panel Features
Top Panel Features
Mounting
Operation
Troubleshooting — If No Image Appears
property damage.
blessures ou dommages matériels.
Check that the installation of the floor box meets government, building, electrical, and
safety codes.
Install the floor box according to the instructions of the manufacturer.
Prepare and pull the cables through the floor box.
TIP:
Secure cables with clamps or ties to provide strain relief.
Trim back and insulate shields with heat shrink.
ATTENTION:
•
To prevent short circuits, the outer foil shield can be cut back to the point
where the cable exits the cable clamp. Both braided and foil shields should be
connected to an equipment ground at the other end of the cable.
•
Afin d'éviter les court circuits, le blindage en aluminium extérieur peut être
réduit jusqu'à ce que le câble sorte de la cosse de câble. Le blindage tressé et
le blindage en aluminium devraient être connectés à la masse d'un équipement
à l'autre bout du câble.
Install the appropriate adapters to the desired position in the floor box (see
Plates
on page 5).
DTP2 T 202 FB • Installation and Operation
Adapter
4