Table of Contents
Advertisement
Figure 9
1. Handle assembly
2. Mounting bracket
F.
Insert the clevis pin through the handle
assembly hole, into the bottom hole of the
mount bracket and through the front panel
of the unit. Install the hairpin through the
hole on the clevis pin (Figure 9).
G.
If the mower deck is not equipped with
belt shield knobs, skip to step H. If the
deck does have belt shield knobs, secure
the loom clip by removing the rear knob
on the belt shield. Place the loom clip
onto the belt shield stud and reinstall the
knob onto the belt shield (Figure 10).
Figure 10
1. Knob
2. Loom clip
H.
Use velcro straps to secure the cable as
shown in Figure 11.
g011362
3. Clevis pin
4. Hairpin
g034186
3. Handle assembly cable
Important: Keep the cable away from
heat sources such as the muffler and
manifold.
Important: Belt shields must be
in place before operating the hand
controlled discharge accessory.
1. Velcro strap
• For Vantage Units:
Note: The trash holder must be removed if it
is installed on the LH side of the unit.
A.
On all Vantage units, the bracket is
installed on the left side panel with the
wide opening pointed toward the rear
of the machine as shown in Figure 12.
Continue with step B for Vantage 48, 52,
and 60 units; skip to step E for Vantage
36 units.
B.
Align the existing hole at the rear of the
unit with the right hole on the bracket.
C.
Position the bracket horizontally or with
the narrow end pointed slightly downward.
D.
Using the mounting bracket as a template,
mark the left hole location onto the side
panel of the unit. Remove the mounting
bracket. Before drilling the left hole
location, make sure the area on the
backside of the side panel is clear. Drill
11/32 inch diameter hole (see Figure 12).
11
Setup
Figure 11
g012625
Advertisement
Table of Contents
