5. Terminal Setup
To configure the system, connect a serial cable to a COM port on a PC or
notebook computer and to the RJ45 type of the console port of the AP Controller.
PC / Workstation
with
Terminal Emulation Software
AP Managed Switch
RS232 to RJ45 Cable
Serial Port
RJ45
Console Port
Figure 5-1 AP Controller Console Connectivity
A terminal program is required to make the software connection to the AP
Controller.
1. Run terminal program "Tera Term" on the OS.
2. When the following screen appears, make sure that the COM port should be
configured as:
z Baud: 115200
z Data bits: 8
z Parity: None
z Stop bits: 1
z Flow control: None
Figure 5-2 COM Port Configuration
10