Canon Pixma MP800R User Manual page 104

1
Display the Read/write attribute screen.
(1) Ensure that the memory card is not set.
If the memory card is set, remove it from the Card Slot. See
on page 49.
(2) Press [Menu].
(3) Use [ ] or [
(4) Use [ ] or [
(5) Use [ ] or [ ] to select <Other settings> and then press [OK].
(6) Use [ ] or [ ] to select <Read/write attribute> and then press [OK].
2
Specify the Read/write attribute.
(1) Use [ ] or [ ] to specify <Read/write attribute>.
USB enabled:
Read-only mode:
(2) Press [OK].
Note
When using the Card Slot as the memory card drive of the computer, the removal operation
from the computer is needed before removing the memory card from the machine.
Over a USB connection:
Right-click the removable disk icon and click [Eject]. If [Eject] is not displayed on the screen,
ensure that the Access Lamp is not flashing and remove the memory card.
Over a wireless or wired LAN connection:
The removal operation is not needed.
Be sure to drag the
102 Reading from and Writing to a Memory Card
] to select <Maintenance/settings> and then press [OK].
] to select <Device settings> and then press [OK].
The Card Slot is used as the memory card drive of a USB-
connected computer only. You can read from or write to the
memory card.
The Card Slot is used only for reading from both USB
connections and LAN connections. Be sure to select this mode
when printing photos from a memory card.
icon into the Trash.
"Inserting the Memory Card"
Chapter 9