Advertisement
Children in the vehicle
64
Suitability of the seats for attaching an i-Size child restraint system
If you use a baby car seat of category 0 or 0+ or a rearward-facing child restraint system of category
I on a rear seat, you must adjust the driver's or front-passenger seat so that the seat does not touch
the child restraint system.
If you use a category I, forward-facing child restraint system, you should remove the head restraint
from the respective seat, if possible (
as far as possible, lie flat against the backrest of the seat.
Always observe the notes in the "Child restraint system" section (
system manufacturer's installation instructions.
Make sure that the child's feet do not touch the front seat. If necessary, move the front seat forward
slightly.
When you remove the child restraint system you must replace the head restraints again immediately
(
page 106). All vehicle occupants must adjust their head restraints correctly before beginning the
Y
journey.
Legend for the table:
X
Seat which is unsuitable for i-Size child restraint systems in the "Universal" category.
i‑U Suitable for a forward or rearward-facing i-Size child restraint system in the "Universal" cate-
gory.
i‑Size child restraint sys-
tems
Recommended child restraint systems
General notes
Always observe the information in "Child restraint systems on the front-passenger seat" (
and in "Suitable positioning of the child restraint system" (
You can obtain further information about the correct child restraint system from any Mercedes-Benz
Service Centre.
page 106). The backrest of the child restraint system must,
Y
Front-
passenger
seat
X
page 56) and the child restraint
Y
Seat
Rear seat
Left
i‑U
page 60).
Y
Right
i‑U
page 59)
Y
Advertisement
